SMC Networks SMC8606T Bedienungsanleitung PDF herunterladen (Seite 127)

NTERFACE

3-31

(Path) Cost 100/19/4 This parameter is used by the STA algorithm

to determine the best path between devices.

Therefore, lower values should be assigned to

ports attached to faster media, and higher

values assigned to ports with slower media.

The default and recommended range is:

Standard Ethernet: 100(50~600)

Fast Ethernet: 19 (10~60)

Gigabit Ethernet: 4(3~10)

The full range is 0 - 65535.

Note: Path cost takes precedence over port

priority.

FastForwarding DISABLED This parameter is used to enable/disabled the

Fast Spanning Tree mode for the port. In this

mode, ports skip the Blocked, Listening and

Learning states and proceed straight to

Forwarding.

FastForwarding enables end-node

workstations and servers to overcome

time-out problems when the Spanning Tree

Algorithm is implemented in a network.

Therefore, FastForwarding should only be

enabled for ports that are connected to an

end-node device.

Parameter Default Description

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 181 182

Keine Kommentare

SMC Networks SMC8606T Bedienungsanleitung Seite 127